Kohler K-702101 Manual Del Usuario página 10

5. Install the Door Panels
NOTICE: Risk of product damage. For the protection of your bath unit, use a drop cloth or similar
material as a protective cover during these steps.
CAUTION: Risk of injury. The door panels are very heavy. Two people should lift them into place.
IMPORTANT! Make sure that the "non coated" label is facing the outside of the bath/shower. The coated
side of the glass panels should face the inside the shower for ease of cleaning.
Install the Inside Panel
From outside of the shower, position the panel with the rollers toward the inside of the shower.
Carefully lift the panel up inside the top track and hang the rollers on the inside rail.
Follow the "Confirm Proper Operation" steps and adjust if needed.
Confirm Proper Operation
Roll the panel back and forth along the track to make sure it operates smoothly.
Carefully remove the caution tape and protective strip from both door panels.
Align the panel with the showerhead side wall jamb next to the inside panel.
If the panel does not operate smoothly, adjustment may be needed. If adjustment is needed, remove
the panel.
NOTE: Moving the rollers to the top hole of the hanger brackets will cause the glass to hang lower.
Moving the rollers to the bottom hole of the hanging brackets will cause the glass to hang higher.
Loosen the roller screw(s) and move the roller to another hole in the hanging bracket. Insert and
tighten the screw(s) and rehang the panel.
1054858-2-B
Inside
Panel
10
Outside
Panel
Kohler Co.