Description (Fig. A) - Ferm OTM1006 Traducción Del Manual Original

• O nly use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use a extension
2
cable reel, always fully unroll the cable.
Technical data
Charger
Input of charger
Output of charger
Rechargeable battery
Battery charging time
No-load speed
Weight
Noise and vibration
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Vibration
Uncertainty (K)
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 62841; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- u sing the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- t he times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DESCRIPTION (FIG. A)

Your multitool has been designed for light sanding,
sawing and scraping applications.
1. O n/off switch
2. S peed adjustment wheel
3. M ounting point for accessories
4. G rip
ASSEMBLY
Before assembly, always switch off the
machine
CDA1139
100-240V~ 50/60Hz 15W
13,5V d.c. 400mA
12 V Li-ion 1.5 Ah
3-5 hours
5,000 - 18,000 min
-1
0.7 kg
94 dB(A)
105 dB(A)
3 dB(A)
11.240 m/s
2
1.5 m/s
2
The battery must be charged before first
use.
Removing the battery from the machine
• P ush the battery unlock buttons and pull the
battery out of the machine
Inserting the battery into the machine
Ensure that the exterior of the battery is clean and
dry before connecting to the charger or machine.
• I nsert the battery (2) into the base of the
machine
• P ush the battery further forward until it clicks
into place.
Charging the battery (with the charger)
• P lug the charger plug into an electrical outlet
and wait for a while. The LED indicator will
lighten up and show the charging status.
LED Charger status
Red Battery charging in progress
Green Battery charging finished, battery fully charged
• F ully charging the 1.5Ah battery may take up
to 240 minutes.
• A fter the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over
a longer period of time it is best to store
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
• P lace the machine on a table with the mounting
point (3) facing upwards.
• L oosen the Allen screw (7) using the Allen key
(5).
• M ount the sanding pad (9) to the mounting point
(3).
• T ighten the Allen screw (7) using the Allen key
(5).
• M ount sanding paper (10) with the required
grain size onto the sanding pad (9). Make sure
that the perforation in the sanding paper (10)
corresponds with the perforation on the sanding
pad (9).
- U se coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
5