Description (Fig. A) - Ferm AGM1086 Traducción Del Manual Original

• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm2. If you use a extension
cable reel, always fully unroll the cable.
Technical data
Mains voltage
Mains frequency
Power input
No-load speed
Grinding disc
Diameter
Bore
Spindle thread
Weight
Noise and vibration
Sound pressure (Lpa) (K=3dB)
Acoustic power (Lwa) (K=3dB)
Vibration (K=1.5 m/s )
2
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 60745; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned
- using the tool for different applications, or with
different or poorly maintainted accessories, may
significantly increase the exposure level
- the times when the tool is switched off or when it
is running but not actually doing the job, may signifi
cantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns
Wear hearing protection.

DESCRIPTION (FIG. A)

Your angle grinder has been designed for grinding
and cutting masonry and steel.
1. On/off switch
2. Spindle lock button
3. Spindle
4. Guard
5. Main grip
6. Auxiliary grip
ASSEMBLY
AGM1086 AGM1087
230 V~
50 Hz
Mounting and removing the guard & grinding
500 W 850 W
disc (fig. B)
11,000/min
115 mm 125 mm
22.2 mm
M14
1.69 kg 1.94 kg
Mounting
•
70 dB(A) 89.9 dB(A)
80 dB(A) 100.9 dB(A)
•
2.5 m/s 5.587 m/s
2 2
•
•
•
•
•
•
Removing
•
•
•
•
•
•
•
•
Mounting and removing the auxiliary grip
(fig. C)
Mounting
•
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Do not use the machine without the guard.
Place the machine on a table with the spindle
(3) facing upwards.
Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
If necessary, remove the grinding disc (9).
Remove the flange (10).
Mount the guard (4). Secure the guard (4) by
tightening the screw (11) and the nut (12).
Mount the flange (10).
If necessary, mount the grinding disc (9).
Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Place the machine on a table with the spindle
(3) facing upwards.
Keep the spindle lock button (2) pressed and
remove the flange (7) using the flange key (8).
If necessary, remove the grinding disc (9).
Remove the flange (10).
Remove the guard (4) by loosening the screw
(11) and the nut (12).
Mount the flange (10).
If necessary, mount the grinding disc (9).
Keep the spindle lock button (2) pressed and
mount the flange (7) using the flange key (8).
Tighten the auxiliary grip (6) into one of the
mounting holes (13).
7