Kohler K-5250 Manual Del Usuario página 5

1-1/4" Drain
Ferrule
Nut
Supply Tube
Ferrule
2. Install the Drain
Remove the temporary 3/8" pipe previously installed into the
supply fitting.
Remove the 1-1/4" pipe installed to the drain fitting.
Install a 3/8" nipple for the supply to extend approximately
7/16" (11 mm) from the finished wall.
NOTE: If the tubing is used for supply, a male threaded adapter
must extend approximately 7/16" (11 mm) from the finished wall.
Assemble the water stop onto the nipple.
Ensure that the screwdriver slot on the water stop is angled at
45°, and that it is facing toward the bottom access.
Ensure that the water stop inlet and outlet are parallel to the
floor.
3. Install the Drinking Fountain
Measure the distance between the finished wall and the center of
the drinking fountain outlet.
Remove the temporary capped nipple.
Replace the temporary nipple with a nipple that will position the
trap inlet directly under the drinking fountain outlet.
Install the two provided wall hangers to the wall, as shown in the
roughing-in diagram. Secure the hangers by the center hole only.
Kohler Co.
Hanger
Hanger
3/8" Supply
Stop Assembly
(Turn to 45˚ angle for access.)
Nut
Control Valve
5 101024-2-AC