Testing Your Fan - Craftmade ELLINGTON BLV54ABZ5 Guia De Instalacion

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with pull chain. (diagram 1) Start at the
OFF position (no blade movement). First pull will
set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. If fan
does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely RIGHT or completely LEFT for fan to
function. If the reverse switch is set in the middle
position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end
of the pull chain.
page 8
reverse
switch
diagram 1
diagram 2
diagram 3
pull chain
extension
diagram 4