Publicidad
SAFETY ADVICE
•
Rion is not responsible for the misuse of tools or parts.
•
It is of utmost importance to assemble all of the parts according to the directions. Please follow them closely and
do not skip any step.
•
We strongly recommend using work gloves during assembly.
•
If using a step ladder or power tools ensure that you follow the manufacturer's safety advice.
•
If local building codes require permits or licenses make sure that they are acquired before beginning.
•
Your Greenhouse should be secure by anchored to the prepared foundation using the recommended hardware.
•
Do not attempt to assemble the greenhouse in windy or wet conditions.
•
Dispose of all plastic bags safely keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not lean against or push the greenhouse during construction.
•
Do not attempt to assemble this greenhouse if you are tired, have taken drugs or alcohol or if you are prone to
dizzy spell.
•
When your Greenhouse is fully assembled examine it for sharp edges and trim with a razor knife if necessary.
•
If you live in a hot climate, where outside temperatures exceed 46° C (115° F) in the sun or 36° C (99° F) in the
shade, this may cause the temperature inside the greenhouse to exceed 55° C (131° F). Such conditions may harm
your plants and will damage the greenhouse by warping structural profiles. In order to prevent damage:
•
Ensure good ventilation during hot days.
•
Make sure that the temperature inside the green house never exceeds 55° C (131° F) by providing a shading
screen, such as the Shade Net (available as an accessories option).
Note: RION is not responsible for any damage due to high temperatures.
* Always close roof vent in high winds.
REQUIRED TOOLS
•
GT1 - Special tool to connect pins through lined up holes. Pin Tool fix and lock profiles in place
•
To assemble this product you will need the following tools (these items are not supplied)
BEFORE ASSEMBLY
•
Rion is not responsible for the misuse of tools or parts.
•
Selecting a site - the greenhouse must be, positioned and fixed on a flat level surface.
•
Sort the parts and check according to the contents parts list. Do not begin assembly if any parts are missing.
•
If you prepare a concrete foundation do not excavate and pour concrete in frozen ground.
•
We recommend that you place your Greenhouse in a spot where it will receive direct sunlight and will be
protected from the wind as much as possible. The door should not face prevailing winds.
DURING ASSEMBLY
Step 1: place door hinge according to the desired direction of the door opening.
Steps 1-4: Arrange all 2D connectors with the stamped word OUT facing the outside of the greenhouse.
Step 5:
•
Make sure that the frame is perfectly straightened by measuring the diagonals and verifying that they are the same.
•
Make sure that the frame is level and anchor it with screw / screw + dibble / spike (not included) according to the
selected surface.
Step 9: Walls assembly must be made gradually (1.panel 2.rofile 3.connector) according to describe method in step #8.
¼"
7 mm
10 mm
Attention:
When encountering the information icon, please refer to the
relevant assembly step for additional comments and assistance.
This icon indicates that the installer should be inside the product.
Publicidad
