Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK PROGRAMMING GUIDE 912-DMH DVB-T
Start/on
Main menu
Transcodificador 912 QPSK - COFDM
Select series
NIT Table
Select series
DMH-101 HDMI to DVB-T modulator
MS-565/569/571 Modulator
DMH-101 HDMI to DVB-T modulator
Configure module
Set the programming switch of the 912-DMH module to the ON position. The programming
Output
Standard
DVB-T
Program by
Channel
Canal
Frequency
Channel table
BG CCIR
Channel
21
Frequency
471.25
14
Attenuation
Offset
0
Bandwidth
8
Mode
8K
Modulation
64QAM
FEC
7/8
Guard interval
1/32
OK
OK
OK
indicator will now light up and remain lit.
OK++OK+T
OK++OK+T
OK++OK+T
Keypad + T
or
OK++OK+T
Keypad + T
MHz
Keypad + T
or
dB
OK++OK+T
OK++OK+T
MHz
Keypad + T
or
MHz
OK++OK+T
OK++OK+T
OK++OK+T
OK++OK+T
OK++OK+T
Press the Power On key of the PS-011 to start up the
system.
Choose Select Series to select the programming series.
Select the series: DMH-101 HDMI to DVB-T modulator.
To commence programming the module, select Configure
module.
Select the COFDM modulation standard. Then press T to
transmit.
Select the programming mode for the output of the
module: channel or frequency. Then press T to transmit.
Select the standard for the output channel. Then press
T to transmit.
If the output is programmed by channel, it is possible to
enter the channel using the numeric keypad. Alternatively,
you can select a channel from the pull-down list. When
you have confirmed your choice by pressing OK, press
T to transmit.
If the output is programmed by frequency, enter the
frequency using the numeric keypad. Then press T to
transmit.
Enter the attenuation at the output of the module
using the numeric keypad. Then press T to transmit.
Select the offset of the output frequency from the options
available. Then press T to transmit.
Select the bandwidth of the output channel. You can do
this using either the numeric keypad or the pull-down
menu. Then press T to transmit.
Select the number of carriers mode in the output channel.
Then press T to transmit.
Select the type of modulation of the output channel. Then
press T to transmit.
Select the output forward error correction rate (FEC).
Then press T to transmit.
Select the guard interval of the output signal. Then press
T to transmit.
ENG
Publicidad
