Alcad 912-DMH Serie Quick Programming Guide página 4

QUICK PROGRAMMING GUIDE 912-DMH DVB-T
Cell ID
0
Service
Service ID
1
Service name
ALCAD S1
Advanced menu
BW total
Orig net ID
1
Network ID
1
TS ID
1
NIT table
Input
Brightness
Contrast
Saturation
Hue
HDMI
HDCP
Video resolution
Set the programming switch of the 912-DMH module to the OFF position. The programming
Advanced
81%
No information
Not generated
Valid
Invalid
Connected
Not connected
Yes
No
No information
1920 x 1080 30p
No information
indicator light will now go out.
You can enter a number of up to 5 digits as the cell
Keypad + T
identifier using the numeric keypad. Then press T to
transmit. Then press T to transmit.
You can use the numeric keypad to enter a number of
Keypad + T
up to 5 digits as the service identifier. Then press T to
transmit.
Using the keypad, enter the name of the service you want
Keypad + T
to modulate. Then press T to transmit.
Audio and video codification menu. It is recommended
that you use the default values.
The total BW shows the bandwidth taken up by the sum
of the two modulated services.
You can use the numeric keypad to enter a number of up
Keypad + T
to 5 digits as the TS identifier. Then press T to transmit.
The status of the NIT table is shown in grey if no relevant
information is available; in green if the NIT table is
READ
correct; and in red if the NIT table contained in the
module is incorrect.
Use the tu keys to adjust the brightness of the input
tu + T
signal. Then press T to transmit.
Use the tu keys to adjust the contrast of the input signal.
tu + T
Then press T to transmit.
Use the tu keys to adjust the saturation of the input
tu + T
signal. Then press T to transmit.
Use the tu keys to adjust the hue of the input signal.
tu + T
Then press T to transmit.
Press the READ key to get the status of the HDMI
connection, HDCP and resolution of video input.
READ
ENG