Playing Music; Scanning For Dab Stations - Fusion Apollo MS-RA670 Guia De Inicio Rapido

3 > BT > CONNECTIONS > DISCOVERABLE.
Select
The stereo remains discoverable for two minutes.
4
Bring the watch within 3 m (10 ft.) of the stereo.
NOTE: Stay 10 m (33 ft.) away from other ANT
5
Open the Fusion-Link Lite app on the watch.
The first time you open the app on the watch, the watch automatically pairs
with and connects to the stereo. If you need to pair to another stereo, in the
Fusion-Link Lite app, select Settings > Pair new.
6
Control the audio playback using the Fusion-Link Lite app on the watch.
After the devices are paired, they connect automatically when they are turned on,
within range, and the app is open on the watch.
Connecting to an ARX70 Remote Control
1
On the stereo, select the BT source.
2
Select > BT > CONNECTIONS > DISCOVERABLE.
3
Bring the ARX70 remote control within 10 m (33 ft.) of the stereo.
NOTE: Stay 10 m (33 ft.) away from other ANT devices while pairing.
4
On the ARX70 remote control, press and hold
alternating green and red.
The remote control searches for the stereo. When the remote control pairs
successfully, the status LED turns on green briefly and then turns off.
If the remote control cannot find the stereo, the status LED turns on red briefly
and then turns off.

Playing Music

Setting the Tuner Region
You must select the region you are in to receive AM and FM stations properly.
6
If you are connected to a compatible SiriusXM
subscription (USA only), you must select the region you are in to receive
SiriusXM stations properly.
NOTE: SiriusXM is not available in all regions.
devices while pairing.
®
If you are connected to a compatible DAB module and antenna (not included),
you must select the region you are in to receive DAB stations properly.
NOTE: DAB stations are not available in all regions.
1
Select
2
Select TUNER REGION.
3
Select the region you are in.
Changing the Radio Station
1 Select an applicable source, such as FM.
2 Select
You can use AUTO mode to scan stations, MANUAL mode to manually tune
to a station, and PRESET mode to select the next preset station.
3
Select
TIP: You can quickly save the selected station or channel as a preset by
until the status LED starts
holding

Scanning for DAB Stations

Before you can scan for DAB stations, you must connect a compatible DAB
module and antenna (not included) to the stereo. Because DAB signals are
broadcast in select countries only, you must also set the tuner region to a
location where DAB signals are broadcast.
1 Select the DAB source.
2
Select
When scanning is complete, the first available station in the first ensemble
found begins playing.
NOTE: After the first scan is complete, you can select
DAB stations. When the re-scan is complete, the system starts playing the
® tuner and antenna, and have a
> SETTINGS.
to select a tuning mode.
or to tune to the station.
.
to scan for available DAB stations.
again to re-scan for
Quick Start Manual