Preparations For Operating - ESAB Cutmaster 40 Manual De Instrucciones

ESAB CUTMASTER 40

4.02 Preparations For Operating

At the start of each operating session:
WARNING
Disconnect primary power at the source before assembling or disassembling power sup-
ply, torch parts, or torch and leads assemblies.
NOTE!
All consumables must be correctly installed and maintained to ensure correct operation.
A. Torch Parts Selection
Depending on the type of operation to be done determines the torch parts to be used.
Type of operation:
Drag cutting, standoff cutting or gouging
Torch parts:
Shield Cup, Cutting Tip, Electrode and Starter Cartridge
NOTE!
Refer to Section 4T.07 and following for additional information on torch parts.
Change the torch parts for a different operation as follows:
WARNING
Disconnect primary power at the source before assembling or disassembling power sup-
ply, torch parts, or torch and leads assemblies.
NOTE!
The shield cup holds the tip and starter cartridge in place. Position the torch with the
shield cup facing upward to keep these parts from falling out when the cup is removed.
1. Unscrew and remove the shield cup assembly from the torch head.
2. Remove the Electrode by pulling it straight out of the torch head.
OPERATION
Torch Head
Electrode
Start Cartridge
A-03510_AB
Torch Parts (Drag Shield Cap & Shield Cup Body Shown)
Tip
Shield Cup
4-2 300X5394