Installation Guide; Using The Appliance For The First Time; Installation Procedure - Westinghouse 1804 Operación Manual

INSTALLATION GUIDE

USING THE APPLIANCE FOR THE FIRST TIME

1. Read the instruction manual and retain for future reference.
2. Remove all packaging materials, use a soft dry cloth to clean all the parts then
re-assemble parts back together.
3. Placing the appliance on a dry, solid, level surface, and ensure the appliance is
provided with reasonable space of at least 10 cm from any objects, in order to
operate effectively.
4. Check power sockets and any extension cords to confirm compliance with
appliance requirements. Ensure that the appliance is plugged in before usage.
5. When the appliance is turned on for the first time, warm air and mineral smell
may be released from the air outlet. This is normal as catalytic oxidation is
taking place inside the NCCO Reactor.

INSTALLATION PROCEDURE

1. Hold the button on the side of panel and lift up the panel cover with another
hand.
2. Remove the packaging materials of the NCCO reactor as well which is on
top, inside of the gift box.
3. Take out the HEPA Filter and remove the packaging materials.
4. Place the HEPA filter to the NCCO reactor to make it as a filter set.
5. Install the filter set into the appliance's body. Press it down firmly.
*Make sure the filter set fits to the appliance's body well.
6. Restore the cover to its original position by pressing it down till a snap sound
is heard. Connect to power supply and press the power button to switch on
the appliance.
WARNING
If Filter and NCCO Reactor
are not properly installed the
unit will not work and alert you.
Redo the installation making
sure, it is done properly and
try again.
7