Teka STROHM Icon TK Manual Del Usuario página 20

PRODUCT GUARANTEE / INSTALLATION NORMS
 Place the shower tray on its final position with the drainage facing the shower waste
following manufacturer's instructions.
 It is necessary to use a non-symphonic waste if installation has already a drain trap.
Otherwise, the capacity of evacuation of the installation can be affected.
 Preferably, the shower tray should fit into the walls between 0.5cm and 1cm so that
the plating behind the wall leans on it what will guarantee an anti-leak union.
★ It is advisable to leave a margin of some 2mm between tile and tray that
after sealing it with silicone would play the role of expansion joint.
 Adjust the tray checking if is tight and levelled in both ways, so that it can drain well
before plating the rest of wall or mounting the shower enclosures.
★ TEKA will never take the charges for substituting shower enclosure or
ceramics on the tray.
 Take off the plastic of protection and seal with silicone the entire perimeter in touch
with the wall with anti mould neutral silicone anti mould allowing it to dry for at least
24h before using the tray.
★ Chemical silicone in touch with shower trays can cause discoloration and
even cracking of tray surface.
 Check that the tray is well installed and drains correctly before proceeding with the
installation of other elements.
➢ The shower trays that have been cut whose length is lower than
900mm must be mounted with the cut part concealed into a wall.
Otherwise, the correct mounting of shower enclosure will not be
possible.
8