Initializing All Settings (Factory Reset); Appendix; Status Indicator Operation Table - Yamaha MusicCast SUB 100 Manual De Instrucciones

Initializing all settings (factory reset)

1
2

STATUS indicator operation table

The color and lit/flashing state of the indicators shows the status of this unit.
NOTE
● The STATUS indicator and the
(→ p. 18 "Checking the firmware version")
● While the firmware is being updated, the STATUS indicator and the
the progress. (→ p. 18 "Firmware update procedure")
When the power is on
Indicator
Green Lit
White Lit
Green Flashing
White Flashing
Green/Orange
Flashing
alternately
White/Orange
Orange Lit
Blue/Purple/Red Lit
Blue/Red Flashing
When in standby mode
Indicator
Orange Lit
– Unlit
Orange Flashing
(rear panel)

APPENDIX

Wireless LAN indicator can be used to check the firmware version of this unit.
The rear panel INPUT switch is set to NET.
The rear panel INPUT switch is set to ANALOG.
Waiting to connect to the network.
New firmware is available.
The auto power standby function will soon put the unit in standby mode. (Starts
flashing 30 seconds beforehand.)
The unit is in network standby mode.
The unit's volume is being changed.
Blue: low volume – Purple: medium – Red: high volume
The volume was set to minimum or maximum.
The unit is in network standby mode.
The unit's power is off or in eco standby mode.
The protection circuit has operated. Turn off the power of the unit, disconnect the
power plug from the AC outlet, and contact a Yamaha service center.
1. On the rear panel, press A (STANDBY/
ON) to put the unit in standby mode.
2.
While holding down CONNECT, press
A (STANDBY/ON) once.
3.
When the STATUS indicator flashes,
release CONNECT.
(top panel)
Wireless LAN indicator can be used to check
Status
Status
APPENDIX
English
19
En