Operating The Product; Remote Control - Dimplex ENGDL20 S E Manual De Instrucciones

Operating The Product

WARNING:
FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN INJURY
AND/OR DAMAGE.
Manual Controls
The Opti-myst Manual controls are located on the base of the appliance.
(See Fig.2 for Manual Control lay out)
Switch 'A':- Controls the electricity supply to the Fire.
Note: This switch must be in the 'ON' ( I ) position for the Fire to operate with or without heat when
activated.
Switch 'B':- Press once to turn on the flame effect. This will be indicated by an audible "beep". Although
the main lights operate immediately it will take a further 45 seconds before the flame effect starts.
Press to put fire into standby mode. This will be indicated by one "beep".

Remote Control

The remote control is packed with 2 AA batteries in a bag. Lift off the battery cover on the back of the
remote control and insert the batteries taking note of the polarity.
Switching on the appliance
Press and hold the ENTER button for 3 seconds to activate the remote control. FIRE will be displayed
and ON will be blinking. Press ENTER to swtich on the appliance. To turn off the appliance press MENU
so that FIRE is blinking, press ENTER twice.
Adjust the Flame Setting
With the remote control activated press once. FIRE will be blinking on the display. Press ENTER. The
current flame setting will be displayed F1-F6. Press the UP and DOWN buttons to adjust the setting. After
you have selected your flame setting press BACK twice to exit the menu and return to the home screen.
Switching on the Heat
With the remote control activated press MENU once. FIRE will be blinking on the display. Press ADV once,
HEAT will be blinking. Press ENTER. The current heat setting will be displayed OFF LO HI. Press the UP
and DOWN buttons to adjust the setting. After you have selected your flame setting press ENTER
Setting the Thermostat
The temperature shown on the display is the room temperature set point. This is the temperature that the
heater will maintain during the heating periods. If the room temperature is above this temperature then the
heater will not operate. The heater leaves the factory with this temperature set at 15ºC which represents
a typical comfortable room temperature. If you require a different room temperature then press either up
or down on the home screen until the display shows the temperature you require.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the fan heater to prevent damage due to overheating. This can
happen if the heat outlet was restricted in any way. If the cut-out operates, unplug the heater from the
socket outlet and allow approximately 10 minutes before reconnecting. Before switching the heater back
on remove any obstruction that may be restricting the heat outlet, then continue normal operation.
6