Seat Adjustment; Armrest Adjustment; Volt Power Outlet - Briggs & Stratton Legacy XL Manual Del Operador

Seat Adjustment

The seat can be adjusted forward and back. Move the lever
(A, Figure 8), position the seat as desired, and release the
lever to lock the seat into position.
Figure 8

Armrest Adjustment

Height
The height of the armrest (A, Figure 9) can be adjusted to
the operator's preference.
1. To increase height, turn the bolt (B) counter clockwise
under the armrest.
2. To decrease height, turn the bolt (B) clockwise.
Width
The armrest width can be adjusted to the operator's
preference.
1. Loosen the four bolts (C) located behind the seat.
2. Slide the armrest toward or away from the seat to a
desired position.
3. Tighten bolts to lock armrests in position.
A
B
Figure 9
XXX
A
C
Parking Brake Operation
Applying the Parking Brake - To lock the parking brake,
release the ground speed pedals (A, Figure 10), fully
depress the brake pedal (B), pull the parking brake knob
(C) out, and then release the brake pedal.
Releasing the Parking Brake - Fully depress the brake
pedal (B) and push in the parking brake knob (C).
C
Figure 10

12 Volt Power Outlet

WARNING Avoid Injury. Safe operation requires your
full attention. Do not wear audio headphones while operat-
ing machine.
The 12-volt accessory power outlet is located in the left
side pod. It can be used to power small electronic devices.
The accessory must be rated at 14 amps or less.
NOTICE Operating a 12-volt accessory, especially with
the engine at idle, may cause battery discharge. When not
using the accessory power outlet, it must be covered with
the rubber plug to prevent moisture from entering. Water in
the power outlet can cause a short circuit.
B
A
19
en