Replacing The Belt - SNOWJOE 24V-SS13 Manual Del Operador

Fig. 17

Replacing the Belt

m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1. Disassemble the left side cover by removing the
five (5) screws that hold it in place (Fig. 10).
2. To remove the old belt from the drive wheel, use one hand
to slowly turn the auger while use the other hand to lift the
belt (Fig. 18).
Fig. 18
3. Replace a new belt in place. Place the left side cover back
into position and refasten the five (5) screws.
Replacing the Scraper Bar
m
WARNING!
Make sure to turn off the unit and remove
the battery before performing any maintenance task on your
cordless snow shovel.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper bar to the base of
the unit (Fig. 19).
Fig. 19
Remove
the screws
2. Remove the old scraper bar (Fig. 20).
Fig. 20
Scraper bar
3. Install the new scraper bar and fasten it securely to the
housing with the four (4) screws (Fig. 21).
Fig. 21
Drive
wheel
Belt
Auger
Fix with
the screws
Lubricating the Cordless Snow Shovel
This cordless snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
Storage
1. Examine the cordless snow shovel thoroughly for worn,
loose or damaged parts. Should you need to repair or
replace a part, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
customer service center at 1-866-SNOWJOE
(1-866-766-9563) for assistance.
2. Remove the battery from the cordless snow shovel
before storing.
13
+
®
+ Sun Joe
® ®