Kohler K-5814 Manual Del Usuario página 6

Preparation (cont.)
Cut-Out
Information
Product Model
Name Number
Aperitif K-6540
Napa K-5848
Sorbet K-5902
** Can also be installed using a metal frame. Reference the metal
frame installation instructions.
Install the water supplies and drain piping according to the
roughing-in information.
NOTE: Tile backer board installed over plywood is the
recommended underlayment for installing this lavatory. Tile should
be bonded to the backer board with dry set or latex Portland mortar.
Acceptable underlayments include:
• Tile backer board over 3/4" (1.9cm) exterior grade plywood
• 3/4" (1.9cm) exterior grade plywood
IMPORTANT! Do not use:
• Flakeboard
• Interior grade plywood
• Gypsum wallboard
NOTE: Consult with a tile contractor to determine the material to be
used.
Determine the desired location for the sink. Draw the cut-out line
based on the measurements provided in the Cut-Out Information
table. Provide adequate clearance between the sink, cabinet, and
backsplash.
1019943-2-A
Sink O.D. Cut Out (A
x B)
16" 14-3/4"
(40.6cm) x (37.5cm) x
19" 17-3/4"
(48.3cm) (45.1cm)
18-3/4" 17-1/2"
(47.6cm) x (44.3cm) x
20-7/8" 19-5/8"
(53cm) (49.8cm)
15" 13-3/4"
(38.1cm) x (34.9cm) x
15" 13-3/4"
(38.1cm) (34.9cm)
6
Radius (R)
2-5/16"
(5.9cm)
1" (2.5cm)
2-1/8"
(5.4cm)
Kohler Co.