turboblender TB-HCON4P PLUS Manual De Usuario página 17

The connection of the power cord must be in accordance with electrical safety standards.
Check the voltage and frequency, see if they comply with the request parameters on the product name-
plate before connecting.
A bipolar switch must be installed between the product and the power cord. W henthe machine is in the
load operation, the voltage error does not exceed 10%.
7. Power Cord Connection
Use an appropriate screwdriverto firmly fasten and fixed the cable.
8. Water Inlet connection
9. Use the water inlet pipe to connect water taps with electromagnetic valve inlet which on the rear of the
box, and add a filter on fitting end of water pipe against blocking of the electromagnetic Valve.
10. Excess steam will be discharged from the exhaust pipe, which on the back of the oven.
Attention
This product must be connected to the ground in safely before use
When connecting the power cord, please operate as shown figure: Insert copper bridges and power lines
under the screw, carefully tighten the power cord and make the copper bridge rest on the power cord
firmly.
f the connection is improper, it may cause joint heating, and burn off power cord.
The voltage of power supply on this equipment must agree with the voltage of power supply on the
product card.
Behind the furnace is equipped with a grounding screw, the copper wire should not be less then 1.5Mts,
and it should be securely connected with ground which meet the safety requirements.
After installation, you should check all wiring for loose ends, whether voltage is normal, and whether the
safety connect ground is credible.
Fixed wiring of the device must be connected with all-pole disconnect switch according to wiring rules.
And on each pole switch should have at least 3mm contact separation, andsuggest installing earth leaka-
ge protection switch. For easy operation, not allowed to pile up things in front of switch.
Do not store any flammable items in the vicinity of the installation location. Ambient temperature is lower
then 45° C, relative humidity is below 85%.
Special Remarks
1. Not suitable for home use. This product is a commercial machine to be operating by a trained chef.
2. it can not be shaken and tilting when operation.
3. Do not disassemble and refit the product, which will lead to serious accidents.
4. Please don't open the enclosure of the product. Product inside contains high-voltage circuit. disassem-
bling shell may lead to electric shock.
5. Please make sure to pull out the plug and cut off the power before cleaning.
The power of what you want. El poder de lo que querés.
17