AFTER USE
• Switch off the appliance by pressing the ON/OFF button.
• Unplug the
appliance.(fig. 24)
• Do not drain the water tank immediately right after use. Please wait one hour before draining.
• Hang the steam head in an upright position on the hook steam head.
Warning: never remove the Press & Steam accessory for storage before it has completely
dried. Always roll the Press & Steam vertical support for storage. Do not crease it.
• Empty the water tank each time before storage in order to flush out any scale particles.
(fig. 25)
• Loosely wind up the electrical cord with the tie, then hang it on the cord hook on the pole.
(fig. 28)
Warning: Never touch the steam head until it has cooled down completely.
1 • Transport
• Push back the 2 stability legs.
• You can transport your appliance by lifting it up both by the telescopic pole and by the
appliance's handle.
Do not attempt to lift up or transport the appliance holding the integrated hanger.
2 • Maintenance and cleaning
Easy descaling
This process should be made every 6 months or as soon as you feel that the performance
of the appliance (steam output) is decreasing.
• Unplug the appliance.
• Wait an hour so that the appliance has completely cooled down.
• Remove the hose from the housing: Unlock it by turning anti-clockwise and then pull up to
remove the hose.
• Remove the anti-calc cap by unscrewing.
• Rinse the appliance with cold water (cold appliance).
- Pour 500 ml of water into the anti-calc opening
- Pour 500 ml of water into the hole connection
- Gently shake the appliance
- Vertically tilt the appliance to empty the water into the sink
• Descale the appliance with a preparation of white vinegar / water (cold appliance).
- In a bottle, mix by adding 500 ml of white vinegar and 500 ml of water
- Pour half of the bottle into the anti-calc entry
- Pour the other half into the hole connection
- Leave the product containing the solution over night
- Gently shake the appliance
- Vertically tilt the appliance to empty the water into the sink
10
(fig. 26-27)
(fig
30).
(fig. 23)
(fig
25).
(fig
31).
* depending on model