6.
Using an 8 mm socket wrench, remove the three hinge screws.
Using a Phillips screwdriver, remove the ground screw (left freezer door ).
7.
NOTE: Provide additional support for the door while the hinge is being
removed. Do not depend on the door gasket magnets to hold the door
in place while you are working.
8.
Remove the top left freezer door hinge.
9.
Using both hands, slowly swing the door until it is open to a 90° angle
door onto a soft surface to protect the finish.
10.
Repeat this procedure to remove the right refrigerator door.
REPLACE DOORS
NOTE: The hinge pin extends from the bottom edge of the door.
Insert the hinge pin into the opening in the bottom hinge.
1.
2.
Insert the top hinge into the top of the door.
Using the hinge screws removed earlier, fasten the top hinge to the top
3.
of the cabinet.
Replace the ground screw (left door).
4.
5.
Reconnect the water tube.
6.
Replace the left door following steps 1 through 3.
7.
Using the four screws removed earlier, fasten the hinge cover to the
top of the cabinet.
Hinge screws
Ground screw
Top hinge
90°
13