HoMedics SOUNDSPA Manual De Instrucciones E Información De Garantía página 4

FIGURE 4
FM/AM
HIGH/LOW
FIGURE 5
AL SET
POWER
(+LED)
FM
PM
TIMER
AL MODE
PROJECTOR
ON/OFF
DC JACK
RADIO
SOUND
HOUR MINUTE
BEEP
6
Setting the Clock
1. Press and hold the HOUR button for 5 seconds (Fig. 5). The time will begin to flash
2. While the time is flashing, press the HOUR button until you reach the correct hour. Then press the
MINUTE button (Fig. 5) until you reach the correct minute.
NOTE: PM indicator will appear on the left side of the clock face for evening hours (Fig. 5). If the
NOTE: After 5 seconds, the time will stop flashing and it will be set.
3. Press the BACKLIGHT HIGH/LOW button (Fig. 4) to choose between high and low clock brightness.
Listening to Nature Sounds
1. Select the sound you wish to listen to and press the corresponding button (Fig 2).
2. To adjust the volume, turn the VOLUME knob (Fig 1) to your desired level.
3. When finished listening to the sounds you may turn them off by pressing the POWER button, or
switch to the radio by pressing RADIO (Fig 5).
NOTE: When the unit is turned on it will always default to the last mode used.
Listening to the Radio
1. Press the RADIO button (Fig 5).
2. Rotate the TUNER (Fig 1) to select a radio station.
3. To adjust the volume, turn the VOLUME knob (Fig 1) to your desired level.
4. When finished listening to the radio you may turn it off by pressing the POWER button, or switch to
a nature sound by pressing the corresponding button (Fig 2).
NOTE: To change between bands there is an AM/FM switch located on the back of the unit (Fig 4).
RADIO
(+LED)
PM indicator is not illuminated, the hour is set to AM. Be sure to set the time for the correct
12-hour period – AM (morning) or PM (evening).
When FM band is selected, a FM Indicator will appear on the left side of the clock face
(Fig. 5). If the FM indicator is not illuminated, the band is set to AM.
7