Publicidad
Idiomas disponibles
Idiomas disponibles
5. When the alarm sounds you may either:
a. SNOOZE: Press the SNOOZE button (Fig 3). Your sleep time will be extended by
9 minutes. You may use this feature until you turn the alarm off.
b. RESET: Turn the alarm off by pressing ANY button on the unit, except for the
SNOOZE button (Fig 3). The alarm clock will automatically reset for the next day in
it's current mode. A green LED will indicate this. If you wish to change the wake
mode follow step 1 under Setting and Using the Alarm.
c. OFF: To completely turn off the alarm so it is not set for the next day continue to
press the AL MODE button until all the Alarm Mode LED lights are off (Fig 4).
NOTE: If the alarm sounds for 30 minutes continuously it will automatically turn off.
Using the Projection Feature
1. To turn the projection feature on, slide the switch on the back of the unit (Fig 5) to the ON position.
The time is now projected on the ceiling.
NOTE: If the projection feature is off you may press the SNOOZE button (Fig 3) to trigger 5 seconds
of projection.
2. To turn the angle of the time that appears on the ceiling, rotate the TIME ROTATION KNOB until you
have reached your desired result (Fig 5).
NOTE: The TIME ROTATION KNOB will rotate up to 350 degrees.
FIGURE 5
FOCUS KNOB
FM/AM
HI/LOW
TIME ROTATION
KNOB
8
PROJECTOR
ON/OFF
DC JACK
3. To focus the time on the ceiling rotate the focus knob until you have reached your desired result.
4. The angle of the projector can be adjusted by angling forward or backward.
Maintenance
To Store
You may leave the unit on display, or you can store it in its box or a cool, dry place.
To Clean
Wipe off dust with a damp cloth. NEVER use liquids or abrasive cleaner to clean.
Modifications not authorized by the manufacturer may void users authority to operate this device.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
9
Publicidad
