Coupling - Nogueira Tn-10 Manual De Instrucciones

Coupling

The Chopper TN-10 Nogueira universal accessory is coupled with the three points of the
tractor being operated by means of cardan shaft on tractors that have a minimum output
of 65 hp at 540 RPM on the tractor's power take-off.
The Chopper TN-10 Nogueira can be equipped with base coupling to electric
motor drive.
BELTS
TN-10
Nozzle output side:
The nozzle output side is coupled as follows:
1- Loosen the screws "A" and remove the output side of the exit "B" (fig.03).
2- Place the nozzle exit side "C" in place of the cover and tighten the screws "A" again (fig.04).
3
B
Belt tensioner (Accessory Universal:
Remove the belt cover and check the belt tension
by forcing it down manually, the belt should yield
1,5 to 2 cm, otherwise, proceed as follows:
Loosen the screws on the frame of the pulley,
adjust the belt tension by tensioning nut "A"
(fig.05), before using the machine, tighten the
screws on the frame of the pulley. When you stop
the machine for more than twenty days, we
recommended that you loosen the belt for added
durability.
TYPE
(5x) B-105
A
TN-10
ROTATION OF THE TN-10
1800 TO 2000 RPM
4
C
5
A
A
15