Installing The Tool-Less Rail Solution - Dell PowerEdge C8000 Introducción Al Sistema

Installing the Tool-Less Rail Solution

WARNING:
avoid injury, do not attempt to lift the system by yourself.
WARNING:
personal injury or damage to the system, you must adequately support the system
during installation and removal.
WARNING:
grounding conductor is necessary for the rack installation. The rack equipment
must provide sufficient airflow to the system to maintain proper cooling.
CAUTION:
The rail pegs must be flush with the rack posts to install
properly.
NOTE:
The rack rails are marked LEFT and RIGHT. The rail marked "LEFT" attaches
to the left rack posts and the rail marked "RIGHT" attaches to the right rack posts
when facing the front of the rack.
1 Determine where to place the rails in the rack. Make sure there is enough
space in the rack for the 4U chassis. In a standard rack, the height of a 4U
chassis will span 12 rack post holes.
2 Use the marking indicated on the left and right sides of the rail to orient
the rail correctly to the rack posts.
3 Attach the left rail and stopping bracket to the rack.
Position left rail marked "LEFT" to align with its mounting holes on the
a
rack posts.
Press and hold the rail release button ‚ to open the latch on the front
b
end of the left rail.
Align the three pegs — with the mounting holes on the front rack post.
c
Release the button ˜ when it engages to the front rack post.
d
NOTE:
Make sure the rail release button is engaged correctly.
NOTE:
The rails can be used in both square-hole and round-hole racks.
4
Getting Started With Your System
Whenever you need to lift the system, get others to assist you. To
The system is not fixed to the rack or mounted on the rails. To avoid
To avoid a potential electrical shock hazard, a third wire safety