Labels - SafeWaze OSHA 1910 Manual Del Usuario

14.0 Labels

75
70
WARNING
65
This clearance chart
60
only applies to
55
Horizontal Lifeline
50
systems installed at
45
or above Dorsal
40
D-ring Height, with
35
users connected to
30
the HLL System with
25
a 6 ft. Energy
20
Absorbing Lanyard.
For additional 15
information see
10
User's Manual.
5
10
019732
Manufacturer's instructions supplied with this product at time of shipment must be
read and understood prior to use. Ensure Horizontal Lifeline is installed at an
elevations which will limit Free Falls to a maximum of 6 feet when using Energy
Absorbing Lanyards, and installed overhead when using Self Retracting Lifelines.
This equipment must be installed under the supervision of a Qualified Person.
Inspect all connections prior to use and verify connecting components are installed
correctly. Failure to make secure connections could result in serious injury or death.
Not flame or heat resistant. Avoid contact with sharp and abrasive edges. Caution
should be taken using this equipment near Hazardous Thermal, Electrical, or
Chemical Sources. Equipment exposed to fall arrest forces should be immediately
removed from service. Alteration or misuse of this product, or failure to follow
instructions could lead to serious injury or death. DO NOT REMOVE THIS LABEL.
019702
Carabiner
Label Pack
Anchorage
019738
CLEARANCE CHART FOR 1 TO 2 WORKERS
20 30 40 50 60 70 80 90 100
SPAN LENGTH (FT)
WARNING
Typical Installation
Cross-Arm Strap
Turnbuckle
Attachment O-Ring for User
Fist Grips
Steel Cable
Coil Energy Absorber
Max. 60 ft Span Length
J F M A
019704
Fall Arrest Systems
COIL ENERGY ABSORBER
COIL ENERGY ABSORBER
THIS COIL ENERGY ABSORBER IS DESIGNED FOR
USE AS PART OF A SAFEWAZE HORIZONTAL
LIFELINE SYSTEM, OR AS A COMPONENT OF A
HORIZONTAL LIFELINE SYSTEM WHICH MAINTAINS
A SAFETY FACTOR OF AT LEAST TWO. SYSTEM
MUST BE DESIGNED, INSTALLED AND USED UNDER
THE SUPERVISION OF A QUALIFIED PERSON. USER
SHOULD REFERENCE OSHA REGULATIONS. DO
NOT USE AS A PERSONAL ENERGY ABSORBER.
USER MUST FOLLOW MANUFACTURER'S
INSTRUCTIONS SUPPLIED WITH THIS PRODUCT AT
TIME OF SHIPMENT. MISUSE OF THIS PRODUCT OR
FAILURE TO FOLLOW MANUFACTURER'S
INSTRUCTIONS COULD RESULT IN SERIOUS INJURY
MATERIAL - STAINLESS STEEL
MEETS OSHA 1926.502 AND 1910.140 REQUIREMENTS
DYNAMIC PULLOUT LOAD - 2500 LBS.
AVERAGE DYNAMIC PULLOUT LOAD - 2000 LBS.
MAXIMUM PULLOUT - 48.5 INCHES
ULTIMATE STRENGTH - 5000 LBS
01287z
V1.4 2019 Copyright SafeWaze
BARCODE
HORIZONTAL LIFELINE SYSTEM
PART NUMBER:
SERIAL NUMBER: XXXXXXX
019731
INSPECTION: SYSTEM MUST BE INSPECTED
PRIOR TO EACH USE TO DETERMINE IF IT IS IN
GOOD WORKING CONDITION WITH ALL SYSTEM
CONNECTIONS PROPERLY SECURED. THE
SYSTEM SHOULD BE INSPECTED AT LEAST
MONTHLY BY A COMPETENT PERSON OTHER
THAN THE USER. IF INSPECTION REVEALS A
DEFECTIVE OR UNSAFE CONDITION, THE
SYSTEM MUST BE REMOVED FROM SERVICE.
THIS SYSTEM IS NOT USER REPAIRABLE.
019703
SPECIFICATIONS: THIS HORIZONTAL LIFELINE SYSTEM
IS DESIGNED FOR USE BY UP TO TWO WORKERS.
MAXIMUM WEIGHT FOR EACH WORKER INCLUDING
TOOLS AND EQUIPMENT IS 310 LBS.
MATERIALS: Cable: Galvanized Steel
THIS HLL SYSTEM MEETS OSHA REQUIREMENTS FOR
FALL PROTECTION WHEN USED AS DEFINED IN THE
USER'S MANUAL
019739
Inspection Log
Do Not Remove Label
M J J A S O N D
• Confined Space • Engineering • Rescue Systems
019-8029
WARNING
OR DEATH!
SPECIFICATIONS:
Safewaze.com
322 Industrial Court
Concord, NC 28025
(800) 230-0319
User Manual
30' GALVANIZED CABLE
019-8016 MFG DATE: XX/XX
WWW.SAFEWAZE.COM
Tensioner / Turnbuckle: Galvanized Steel
Anchor Straps: Polyester
Hardware: Steel
Page 21