Controlling The Tv; Switching On; Using The Remote Control; Using The Controls On The Tv - Toshiba 24D153DG Serie Manual Del Usuario

A wide variety of external equipment can be connected via the sockets located on the side and back of the
TV. Whilst all the necessary adjustments and controls for the TV are made using the remote control, the
menu wheel on the left side of the TV may be used for some functions.

Switching on

If the standby LED is unlit, check that the mains plug is con-
nected to the power and press the middle of the
on the left side of the television or
control to switch the television on.
To put the television into Standby, press
remote control or press and hold the middle of the
on the left side of the TV. To view the television, press again.
The picture may take a few seconds to appear.
Note: The active Standby LED colour will turn to red in a few
moments when the TV is switched into Standby.
For energy saving:
Turning the TV off at its mains supply, or un-plugging it, will
cut energy use to nearly zero for all TV's. This is recom-
mended when the TV is not being used for a long time, e.g.
when on holiday.
Reducing the brightness of the screen will reduce energy use.
Note: Putting the TV into standby mode, will reduce energy
consumption, but will still draw some power.

Controlling the TV

Standby LED
Press the MENU button on the remote control to see the
menus.
button
The main menu appears as a group of icons each for a menu
button on the remote
option. Press the Left or Right button to select a topic.
In sub menu screen mode the menu appears as a list. Press
button on the
the Up or Down button to select a topic.
button
To use the options press the Up and Down buttons on the
remote control to move up and down through them and OK,
Left or Right buttons to select the required choice. Follow the
on screen instructions.
Using the menu wheel on the side of the TV:
English - 10 -
IR receiver
Up Direction
Programme / Volume /
AV / Standby-On
selection switch
Down Direction

Using the Remote Control

Using the Controls on the TV

To change volume: Press the middle button until the
volume level OSD appears. Increase the volume by
pushing the button up. Decrease the volume by pushing
the button down.
To change channel: Press the middle button until the
channel information banner appears. Scroll through the
stored channels by pushing the button up or down
To change source: Press the middle button until the
source list appears. Scroll through the available sources
by pushing the button up or down.
Please always refer to the owner's manual of the equipment
to be connected for full details.
To turn the TV off: Press the middle of the button down
and hold it down for a few seconds, the TV will turn into
standby mode.