Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr ANGLE GrINDEr
WArNING:
FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT SAFETY rULES.
If you use this tool unsafe or incorrectly, you can suffer serious personal injury!
• Hold the tool by insulated gripping surfaces
may contact hidden wiring. Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator.
• Always use proper guard with grinding wheel.
wheel fragments.
• Accessories must be rated for at least the speed recommended on the tool
warning label.
Wheels and other accessories running over rated speed can flay apart and cause injury.
• Grinding wheel and guard must be securely attached as described in this
manual
before connecting the grinder to a power source. Make sure that the guard is in good before
operating the grinder.
• Check the grinding wheel carefully visible defects before operation.
cracked, chipped, or warped wheel immediately. Run the tool (with guard) at no load speed for about a
minute, holding tool away from others. If wheel is flawed, it will likely separate during this test.
• Always use safety glasses or goggles.
• When using depressed center grinding wheels, be sure to use only
fiberglass reinforced wheels.
• Use only flanges and clamp nut specified for this tool.
nut on the grinding wheel. Excessive tightening can cause the wheel to crack during operation.
• Be careful not to damage the spindle, the flange, or clamp nut
installing surface) or the lock nut. Damage to these parts could result in wheel breakage.
• NEVEr use tool with wood cutting blades or other saw blades.
used on a grinder frequently kick and cause loss of control leading personal injury.
• Hold the tool firmly with both hands.
• Keep hands away from rotating parts.
• Make sure cord is clear of wheel.
is lost, cord may become wrapped around you and cause personal injury.
• Make sure the wheel is not contacting the workpiece
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFOrT Or FAMILIArITY WITH PrODUCT (GAINED
Do not wrap cord around your arm or wrist. If control of tool
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
when performing an operation where the tool
A guard protects operator from broken
Ordinary eye or sun glasses are NOT safety glasses.
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
Replace
Do not over tighten the clamp
(especially the
Such blades when
before the switch is turned on.
5
Publicidad
Tabla de contenido
