Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Catalogue
Installation
Transport
Move cautiously. Do not grasp any salient parts of machine. The machine door can not be
used as the handle for delivery. If the dryer can't be transported erect, the dryer could be slant
to right less than 30° .
Installation Position
1.It is recommended that, for your convenience, the machine is positioned close to your washing
machine.
2.The tumble dryer must be installed in a clean place, where dirt does not build up. Air must be able
to circulate freely all round the appliance. Do not obstruct the front air inlet or the air intake grilles
at the back of the machine.
3.To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm
and level surface.
4.The feet must never be removed. Do not restrict the floor clearance through deep pile carpets,
strips of wood or similar. This might cause heat built-up which would interfere with the operation
of the appliance.
Level Adjusting
Once in its permanent operating position,
check that the dryer is absolutely level with the aid
of a spirit level. If it is not, adjust the feet with a tool.
Power Supply Connection
1.Make sure that the voltage of the power supply is the same as the electric specification of the dryer.
2.Do not connect the dryer with the power connection board, the universal plug or socket.
V.1
6
Attention and Advice
Attention
Leave it to stand for 2 hours after transporting (Only EMTD8HP).
Before first use, please use the soft fabric to to clean the inside drum.
a)Put some clean rags into the drum.
【On/Off 】
b)Plug the power, press
.
【Refresh】
c)Select the
Programme, press
d)After finishing this programme, please follow the "cleaning and routine maintenance" (refer to page 16)
to clean the filter door.
During drying, the compressor and the water pump generate some noise which is entirely normal (Only ).
Advice
1.Before drying, thoroughly spin the laundry in washing machine. High spin speed can reduce the drying
time and save energy consumption.
2.For uniform drying result, sort the laundry according to fabric type and drying programme.
3.Before drying, please close zips, hooks and eyelets, button up, tie fabric belts, etc.
4.Do not over dry the clothes, because over dried clothes can easily get creases or shrinkage.
5.Do not dry the articles containing rubber or similar elastic materials such as raincoats, bicycle covers and
etc.
6.The door can be opened only after the programme of the drying machine is completed. Do not open the
door before the programme finished, as the skin may be scalded by steam or hot surface.
7.Clean the lint filter and empty container after each use to avoid extension of drying time and energy
consumption.
8 .. Please choose the related programme when deal with wool material clothes, to make the cloth more fresh
. a nd fluffy.
9.The weight references as follows:
Blended Coats
Jackets (about
(about 800g)
800g in cotton)
Work Clothes
Single Sheets
(upper and lower)
(about 600g in
(about 1120g in
cotton)
cotton)
Undershirts
Underpants
(about 180g in
(about 70g in
cotton)
cotton)
【Start/Pause】
button.
Towel Quilts
Jeans Trousers
(about 900g
(about 800g)
in cotton)
Shirts (about
Pajamas
300g in cotton)
(about 200g)
Socks (about 30g in
blended material)
V.1
7
Publicidad
Capítulos
Tabla de contenido
