Troubleshooting - Worx WG604 Manual Del Usuario

TROUBLESHOOTING

Symptom
Machine does not
start when the switch
is in" ON/I"position.
Machine pressure is
not consistent.
The pressure of
the pump is not
adequate
12 12
No detergent
Lance leaks
13A Electric Pressure Washer
Possible causes
Power cord is not plugged in
Socket is defective
GFCI is triggered
Pump is faulty
Air in line.
Water inlet adapter is clogged
or dirty.
water supply is Insufficient
Water supply is restricted
Diameter of garden hose is
too small
Leak or kick in hose
Wrong nozzle is attached
O-ring needs to be replaced
Solution
Plug in power cord
Check or replace plug, socket, fuses
Press reset on GFCI plug
Contact service center
Remove the nozzle, turn on the machine for a while
and install the nozzle back.
Remove the adapter, rinse it with water and put is back.
open water source completely
Check If the water hose kinks or leaks
Replace with right garden hose
Replace hose or untie kinks in hose.
Attach the soap nozzle
Replace o-ring .If the problem is not solved ,contact
service center to buy a new lance
EN