Key Automation 14A Instrucciones Y Advertencias Para Su Instalación Y Uso página 24

EN
ELECTRICAL CONNECTIONS
1 2 1 2
GND 12/24
GND 12/24
_
_
AC/DC
AC/DC
TX
PH1
PO24 CONNECTIONS
LS1
LS2
V+
ENC
NEG
M-
M+
MA24 ELECTRIC CONNECTIONS
SHIELD Antenna - shield -
ANT Antenna - signal -
COM Common for FLASH, LED, SEN inputs / outputs
FLASH Flashing light output 24Vdc (without regulation) maximum 25W
Courtesy light output 24Vdc (without regulation) maximum 15W (radio channel 4 selecting COURTESY LIGHT
LED
START = 2, COURTESY LIGHT TIME = 0 )
SEN Ambient light sensor input
COM IND output common
IND Gate open warning light output, 24Vdc (without regulation) maximum 4W
COM ELEC output common
ELEC Electric lock output 12Vac, maximum 15VA
EDGE/EDGE Sensitive edge output, NC contact or resistive 8k2
COM STOP output common
Safety STOP NC contact between STOP and COM. This input is considered as a safety device; the contact may
STOP
be broken at any time, cutting out the automation at once and disabling all functions, including automatic closure
NEG Photocell power supply negative output
PH-POW Photocell power supply positive output, 24Vdc (without regulation, maximum 250mA
Photocells (closure), NC contact between PH1 and COM. The photocell is tripped at any time during closure of the
PH1
automation, stopping movement at once and reversing the travel direction
Photocells (opening), NC contact between PH2 and COM. The photocell is tripped at any time during opening and
PH2 closure of the automation, stopping movement at once; the automation will continue opening when the contact is
restored if it was opening, or continue closing if it was closing (see parameter "PHOTO 2")
COM Common for PAR, OPEN, CLOSE and SBS outputs
PARCIAL opening command, NO contact between PAR and COM
PAR
Used to open the gate partially, depending on the software setting
24
FOR ENERGY SAVING
3 4
COM OUT
NC
2
1
RX
GND 12/24
_
AC/DC
TX
Limit switch 1 input (only for SUN)
Limit switch 2 input (only for SUN)
Limit switch / encoder power supply positive common (12 Vdc 50 mA MAX)
Encoder S signal input
Encoder power supply negative
Motor output
Earth
Motor output
1 2 3 4
COM OUT
GND 12/24
_
AC/DC
NC
RX
PH2
PO24 POWER MODULE
(M1 - M2)
T2A
N
L
N.B.: Only for
sliding gates
M