Field Of Application - Würth 1952 006 610 Traducción Del Manual De Instrucciones De Servicio Original

DE
GB
INTRODUCTION
FR
Please read this manual before carrying out any operation.
It is compulsory to read this instruction manual before starting any
NL
kind of action.
The proper operation and full compliance of this product's
ES
performance is guaranteed only if all the instructions provided in this
manual are closely adhered to.
IT
We guarantee that this product complies with the technical
specifications described in this manual.
The manufacturer shall not be held responsible for any improper
PT
uses other than those described herein.
Use protective work gloves, protective footwear, hard hat and safety
PL
goggles.
DA
Misuse:
- This product should only be used as described in this
EL
documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any
damage caused by the incorrect or unreasonable use of
the equipment.
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
10
METHOD OF PREPARATION

FIELD OF APPLICATION

The tool kit described herein is used to mechanically eject seized
and stuck drive shafts from the hub. Thanks to the two screw-in
adapters, the user can either use an existing hydraulic unit or order
it.
The flange TO BE MOUNTED on the hub was designed for hubs of
large-sized cars and vans (working range Ø110-186 mm) with bolt
distribution from 2-/3-/4-/5-to 6-.
Thanks to the set of SPACERS, the FLANGE is not directly fixed to
the hub but spaced from it regardless of hub diameter.
The tool set can also be used with a slide hammer with a sliding rod,
available on request (e.g.: Würth 1952 004 050).
This set consists of:
1 x
1 x
1 x
1 x
6 x
item for removal flange with adapter-reducer-thread from
2-3/4"x16UN to 1-1/2"x16UN, working range Ø110-
186mm
item for Adapter, reducer from 1-1/2"x16UN to M22x2.0
for thrust screw
item for Thrust Screw with tapered tip, M22x2.0xL=250 mm
item for High potential screw lubricant
items for sets of SPACERS for anchoring nuts and bolts
systems, of each type, respectively: 5 x M12x1.25/
M12x1.50/M14x1.50/M14x2.00/M16x1.50/M18x1.50