Cleyver Xdive Manual De Instrucciones página 21

Note : using a wrong SIM card format or improper insertion of the
battery may lead to technical problems that are not covered by the
warranty.
Phone sealing :
Before replacing the back cover of the phone, make sure that no hair,
grain of sand or dust particles are caught in the rubber seal around the
phone as this will compromise the quality of the seal.
Check that the USB port cap and the back cover of the phone are securely
closed to ensure the phone is waterproof.
After taking it out of the water and before opening the back cover of the
phone or the cap of the USB ports, carefully wipe the phone. Shake it
to remove the water from the speaker and then place it in the open air
to dry.
Important :
- Do not use an electric hair dryer to dry it.
- Do not use the phone in hot springs or hot water as the high
temperature can compromise the effectiveness of the seal.
- Do not open the battery cover until the phone is completely dry.
- Do not use detergents or other chemicals to wash the phone,
use only tap water.
Turn on/off the device :
To turn on the device, press and hold the Power On/Off button until the
device's startup logo appears.
To turn off the device, press and hold the Power On/Off key again until it
turns off.
The device lock occurs automatically (if automatic lock is enabled) or by
pressing the cancel key. Unlocking is done by clicking the left function key
and then the * key.
Make calls :
To call, dial the number on the dial pad, or select a number from the
phone's contact list and press the SIM 1 or SIM 2 Call key. To cancel a
call, press the Cancel key.
You can also make a call from the Contacts menu by selecting the
desired contact.
During a call, it is also possible to change the volume, activate the
loudspeaker, start recording the conversation and put the correspondent
on hold.
21