Marking; Periodic Inspection And Repair - Tractel Davitrac Manual De Instalación, De Utilización Y De Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 59
Floor-standing, surface-mounted, offset wall-mounted
and built-in floor bases in combination with the davitrac
jib crane:
GB
• Is identical to equipment that has passed a conformity
examination carried out by APAVE SUDEUROPE
SAS - CS 60193 - 13322 Marseille - France, identified
by the number 0082, and has been tested according
to standards EN 795-A:2012 for 1 operator and
TS 16415:2013 for 2 operators.
The self-stabilising base in combination with a davitrac
jib crane:
• Complies with the requirements of European
Regulation 2016-425,
• Is identical to PPE that has passed an EU type
examination carried out by APAVE SUDEUROPE
SAS – CS 60193 – 13322 Marseille – France,
identified by the number 0082, and has been tested
according to standards EN 795-B:2012 for 1 operator
and TS 16415:2013 for 2 operators,
• Is subject to the conformity assessment procedure
referred to in Module D, under the supervision of a
notified body: APAVE SUDEUROPE SAS - CS 60193
- 13322 Marseille - France, identified by the number
0082.
The EU examination certificate of conformity issued by
APAVE and the declarations of conformity to standards
exclude applications associated with other directives.
Depending on their use, these other products are
subject to a declaration of conformity to:
• Standard EN 1496:2017, rescue lifting system.
• Directive
2001/45/EC,
devices.
• Machinery Directive 2006/42/EC, load lifting.
The label marking of davitrac indicates
a. Trade name: Tractel
b. Product description,
c. Reference standard followed by the year of
application,
d. Product part no, e.g. 286819,
e. CE Logo followed by the number 0082, identification
number of the approved body responsible for
production inspection,
f.
Batch number,
g. Serial number,
h. Pictogram showing that the manual must be read
before use,
o. Minimum breaking strength of the anchor device,
p. Number of individuals: 2 operators maximum,
w. Safe working load,
aa. Date of the next periodic inspection,
ae. Date of first commissioning,
af. Personal fall protection anchor device.
16
rope-suspended

10. Marking

,
®

11. Periodic inspection and repair

An annual periodic inspection is mandatory; however,
depending on the frequency of use, environmental
conditions and regulations of the company or the
country of use, periodic inspections may be more
frequent.
If this equipment is dirty, wash it with plain cold water
and brush with a synthetic brush. During transport and
storage, protect the equipment in moisture-resistant
packaging from all hazards (direct heat source,
chemicals, UV rays, etc.).
Periodic examinations must be carried out by an
authorised and trained technician in strict compliance
with periodic examination procedures.
The following points must be examined:
1. Presence and legibility of marking on the product,
2. Presence of all screws, washers and nuts on the
product,
3. Proper tightening of each screw,
4. Presence and condition of all rods and pins,
5. No deformation, cracking, impact or oxidation,
6. Free rotation of the mast in a base,
7. Free opening and closing of the boom,
8. Free movement of the anchoring head,
9. Proper locking in the folded position,
working
10. Free rotation of all pulleys around their axis,
11. Presence of the retaining stop on the anchoring
head,
12. Presence of the retaining stop on the rotating ring,
13. On a self-stabilising base, inspect the condition of
the 4 screw levelling mechanisms.
The result of these inspections must be recorded in the
inspection register located at the centre of this manual,
which must be kept throughout the life of the product,
until its disposal.
The technician must also complete lines A to E of the
table with the following information:
A: Name of inspector
B: Date of inspection
C: Inspection result OK/NOK
D: Signature of inspector
E: date of next inspection
After arresting a fall, this product must necessarily
undergo a periodic inspection as described in this
article.
Please enquire with Tractel before any repairs

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

286819

Tabla de contenido