Uline SHOP-VAC H-8097 Manual De Instrucciones página 4

CARRIAGE HANDLE ASSEMBLY
1. Take two handle supports and two
1" screws. Place screws through the
hole provided in center of each
support. (See Figure 10)
2. Position tank in upright position.
Facing inlet, put support assemblies
inside tank. Then, place screws
through holes provided on left
side of tank. Make sure the plastic
portion is located inside tank. Turn
supports until back of supports fit flush
against inside curve of tank.
(See Figure 11)
3. Remove any webbing that attaches
tank handles to each other. Take
side tank handle with letter L and
position it on outside of tank where
support assemblies are installed.
The U-shaped cutout on the bottom
end of handle must face the rear of tank. Secure
side tank handle to tank with screws in support
assemblies. (See Figure 12)
4. Repeat steps 1 to 3 using right side of tank and
remaining side tank handle marked with the letter R.
5. Position metal carriage handle
outside of tank and under tank
handles. Be sure to spread ends of
carriage handle when assembling
to prevent damage to tank. Line up
holes in ends of carriage handle
with holes in bottom of tank handles. Make sure
carriage handle is in the U-shaped cut on tank
handles (located towards rear of unit). Secure with
1½" screws provided. (See Figure 13)
PAGE 4 OF 30
ASSEMBLY CONTINUED
SIDE TANK HANDLES ASSEMBLY
1. Attach carriage handle to tank by
Figure 10
inserting bolt through center hole of
handle and tank, secure with nut
provided. Attach side handles with
screws provided. Be sure to spread
ends of carriage handle when
assembling to prevent damage to tank.
Figure 11
(See Figure 14)
BASKET ASSEMBLY
1. Insert basket through center of
carriage handle and slide into
place. (See Figure 15)
Figure 12
SIDE TANK HANDLES ASSEMBLY
1. Attach handles to tank with screws
provided. (See Figure 16)
Figure 13
Figure 14
Figure 15
Figure 16
0620 IH-8097