Mangar Health ELK Manual Del Usuario página 6

ELK
Operating Instructions
• Having positioned the ELK under the patient
and connected it to the 4-Way Hand Control
and Airflo compressor, position a sturdy chair, if
possible, next to the patient for them to hold to
provide additional stability. When in the seated
position, the patient should place their arm on
the chair seat to provide further stabilization.
• Kneeling beside the patient, place them in a
seated position on the ELK (fig.10). If necessary,
place a transfer belt (with looped handles)
around the patient's chest and adjust to fit). Use
the handles on this belt to provide additional
support and stability while elevating.
• Explain to the patient what to expect when the
ELK elevates.
• Press the number 1 button on the 4-Way Hand
Control (fig.11). Steady the patient as the ELK
lifts. Stop inflation when the first (bottom)
compartment becomes hard. The compressor
will automatically stop as each compartment
becomes fully inflated.
• Continue to operate buttons 2, 3 and 4, in
sequence, in exactly the same manner. Support
the patient at all times. Always inflate the ELK
sections from the BOTTOM UP BEGINNING
WITH THE NO. 1 BUTTON.
• When all four compartments are inflated, the
patient may be helped to stand or to transfer
(fig. 12).
• To deflate the ELK, first disconnect the air hose
from the Airflo and then press each of the
buttons on the hand control in turn to reduce
the pressure in each chamber. Once pressure
has been reduced, disconnect each of the air
hoses from the ELK.
• After use, roll the ELK up with the 4-Way Hand Control and re-secure the flap around the ends of the
stability bar (see fig. 1).
WARNING: While in use, never allow a chamber to become partially deflated while any chambers above
it are inflated. Chambers must always be fully inflated from the bottom up, in sequence, in order to
maintain stability.
6
10
11
12