Installing Front Fans; Rotating The Corsair Logo/Case Orientation; Installing Top Fans; Feet Installation And Case Orientation - Corsair CARBIDE Serie Guia De Instalacion

Air240

7. Installing Front Fans

To install forward-facing fans,
first remove the front panel.
To do so, apply pressure to
each side of the panel -- about
an inch below the top, then
repeat the same step an
inch above the bottom – and
slightly pull outwards. If the
front panel doesn't remove
easily after this process, it's
still connected to the rest of
the case; forcing the front
panel free may cause damage.
Insert fans and secure each fan
with screws fastened through
the front of the case. Align
front panel and push it back
into the case.
8. Rotating the Corsair Logo/ Case Orientation
You can remove and rotate
the magnetic Corsair logo to
match the position of the case.
AIR240 STEP7
9

9. Installing Top Fans

To install top fans, remove
the top rear thumbscrews
and slide the panel off. Insert
fans and secure each fan with
screws fastened through the
top of the case. Slide the panel
back on and refasten the rear
top thumbscrews.

10. Feet Installation and Case Orientation

For enhanced stability, peel
off the protective tape from
the rubber feet and firmly affix
each one to the bottom case
corners. The location can vary
depending on how the case is
positioned.
AIR240 STEP9
10