CAMP CHEF GCLOGD Folleto De Advertencias E Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Connect the top ring to the fire pit using the 3 supplied bolts
and screws as shown in Figure 1. Note the brackets should
go on the inside of the fire pit.
2. Arrange the 12 pounds of lava rock around the burner. For a
more realistic looking flame arrange the rock to cover most of
the burner. Be careful not to allow any rock to come between
the igniter electrode and the burner. (See Fig 2)
Fig. 2
DO NOT use this fire pit in a manner other than its intended
purpose. Not intended for commercial use. Not intended
to be installed or used in or on a recreational vehicle or
boat. Keep a fire extinguisher accessible at all times. The
use of alcohol, prescription or nonprescription drugs may
impair the consumer's ability to properly assemble or safely
operate this fire pit. Solid fuels shall not be burned in this
gas fireplace.
FOR OUTDOOR USE ONLY
Do not operate the fire pit indoors, in a garage, or in any other
enclosed area or under overhead construction. Do not operate
fire pit near flammable materials such as decks, fences,
porches or carports. A minimum clearance range of 72" inches
is recommended. Do not use the fire pit near gasoline or other
combustible liquids or where combustible vapors may be
present.
Children and adults should be alerted to the hazards of high
surface temperatures and should stay away to avoid burns or
4
WARNING
clothing ignition. Young children should be carefully supervised
when they are in the area of the appliance. Clothing or other
flammable materials should not be hung from the appliance, or
placed on or near the appliance. Any guard or other protective
device removed for servicing the appliance must be replaced
prior to operating the appliance.
Installation and repair should be done by a qualified service
person The appliance should be inspected before use and at
least annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative that
control compartment, burners and circulating air passageways
of the appliance be kept clean.
Use caution when assembling and operating fire pit to avoid
cuts and scrapes from rough or sharp edges.
DO NOT move the fire pit while it is in use. Allow the fire pit to
cool completely before moving or storing.
When in use, the fire pit must be on a level, stable surface
Fig. 1
in an area clear of combustible material. An asphalt surface
(blacktop) may not be acceptable for this purpose. Do not
operate fire pit on flammable material such as carpet or a wood
deck. Store the fire pit in a dry, protected location.
This fire pit is not intended for and should never be used as a
heater.
DO NOT leave fire pit unattended while in use. Operate the fire
pit with close supervision.
DO NOT operate around children or animals.
DO NOT bump or tip fire pit. If fire pit becomes extremely hot,
allow fire pit to cool completely before handling. If you must
handle the fire pit while it is hot, always wear protective oven
mitts or heat resistant gloves when handling the fire pit or its
components.
DO NOT obstruct flow of combustion air and/or ventilation air
for fire pit.
DO NOT wear loose clothing while operating the fire pit. Tie
back long hair while operating the fire pit. ALWAYS wear fully
covering shoes while operating the fire pit.
Allow fire pit and its components to cool completely before
conducting any routine cleaning or maintenance. Do not move
the fire pit when in use. Allow the fire pit to cool before moving
or storing.
DO NOT use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
An LP cylinder not connected for use should not be stored in
the vicinity of fire pit or any other fire pit. Do not store spare LP