Publicidad
Idiomas disponibles
Idiomas disponibles
Starting up the Powerstream Pro
Checking for leaks
• Lot the water run through the unit for a
few seconds. Check that no pipe joints
leak.
Adjusting the flow
Turn the service valves on, then -
• Turn on the hot tap fully at the sink
• Adjust the outlet service valve till the
water cones out of the tap at the
recommended flow rate for the required
temperature.
Refer to Appendix on page 10 :
Correct flow vs. Temperature.
If the required temperature is different
from the factory setting 113°F (45°C),
turn the Adjustment Spindle (Diagram
5) until the outlet temperature is correct.
• Check that the unit works correctly
when the sink tap is closed and then
opened again; if not adjust the service
valve slightly.
• The outlet shut off valve can be used to
regulate temperature or flow of water
from the unit.
When using the hot water open the tap fully
so that the water temperature is always the
same. If hotter water is desired adjust the
temperature dial and flow rate as
recommended in the Appendix on page 10.
Note:
If the unit is servicing a single lever faucet you
may need to restrict the cold water supply to the
faucet to balance water pressure and improve
performance.
IMPORTANT
Before leaving the site, the installer should
demonstrate the unit to the user and give
him/her this guide.
6
Publicidad
