Dmx Linking; Master/Slave Connection; Filter Installation - Chauvet Professional COLORADO Batten Q15 Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
You can link up to 7 COLORado Batten Q15 products at 120 V, 13 products at 208 V, or 14 products at 230 V. Never
exceed this number. Power linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
• When using this product in an outdoor IP65-type environment, be sure to use IP65 (or higher) rated
power cables and secure unused ports with attached IP65 covers.

DMX Linking

The COLORado Batten Q15 will work with a DMX controller using a 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The COLORado Batten Q15 uses a 5-pin DMX connection for its 9 DMX personalities, ranging from 4-channel to 76-
channel in 1-cell modes and 15-cell modes:
Mode
1-Cell
15-Cell

Master/Slave Connection

The COLORado Batten Q15 uses the DMX data connection for its Master/Slave mode. See the User Manual for
information about how to connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The COLORado Batten Q15 supports RDM protocol that allows feedback to make changes to menu
map options. Download the User Manual from

Filter Installation

The COLORado Batten Q15 includes a filter and a glare shield. Follow the procedure below to install or remove the filter
or glare shield.
1. Locate the end of the product on the side which has the power and DMX input ports.
2. Squeeze the filter locking tabs in. The latch bar will pop up.
3. Slide the filter and/or glare shield in or out.
4. Press down on the latch bar until it clicks into place.
Closed
COLORado Batten Q15 QRG Rev. 2
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Pixel Simple
N/A 4
45 60
www.chauvetprofessional.com
Glare Shield Slot (x2)
Filter Locking Tab (x2)
Wire (Europe)
Brown
Blue
Green/Yellow
Basic
8
64
for more details.
Filter Slots
Open
Screw Color
Yellow/Brass
Silver
Green
Advanced HSIC
10 6
66 76
Latch Bar
Glare Shield
(Uninstalled.
Slide out, flip
over, and slide
back in to install)
EN
2