System Information; Delete Functions - RS Pro 156H Manual De Instrucciones

Coating thickness tester / English
5.4 Adjust gray scale (contrast)
The grayscale adjustment: dot matrix LCD display may not be good in different temperature
& humidity, than you can adjust gray scale to get good LCD display.
A: Press Select button to enter the menu
B: Press up/down button to select the setting
C: Press Select button to enter the setting
D: Press up/down button to select gray scale
E: Press Select button to enter
F: Press up/down button to adjust gray scale
G: Press Select button for ok

6. System information

System version number
A: Press Select button to enter the menu
B: Press up/down button to select the setting
C: Press Select button to enter the setting
D: Press up/down button to select information
E: Press Select button to enter
F: View the system information, then press Back button to return.
Data View
View the stored measured data in each mode.
All-delete: Delete all measured data in group.
A: Press Select button to enter the menu
B: Press up/down button to select view
C: Press Select button to enter view
D: Press up/down button to select working mode
E: Press Select button to enter
F: Press up/down button to view each data
G: Press Back button to return or press Select button to delete this group data.
7. Calibration and Measurement
The gauge can calibrate Zero-point of Fe or Non-Fe, or delete wrong calibrated zero-point of
Fe or Non-Fe.
It suggested that zero-point be calibrated before use.
6
8. Zero-point calibration of Fe or Non-Fe
you can press and hold the ZERO button to Zero-point calibration of Fe or Non-Fe in
measuring mode
In the Fe mode, Zero-point calibration of Fe.
In the Non-Fe mode, Zero-point calibration of Non-Fe (Less than 50UM is effective)
9. Delete Fe or Non-Fe Zero-point
A: Press Select button to enter the menu
B: Press up/down button to select calibration
C: Press Select button to enter calibration
D: Press up/down button to delete zero-point of Fe or Non-Fe
E: Press Select button for Ok
F: Press Back button to return

10.Delete Functions

In MENU system, you can find following function:
A: Delete current data: in measurement interface, you can delete the last data by pressing
Back button.
B: Delete all data: Enter menu-view; you can delete all data and statistics of the Current
C: Delete Group data: Enter menu-view-group data; you can delete this group data by pressing
Select button
11. Trouble Shooting
The following list of error messages explains how to identify and eliminate faults.
Err1: Fe probe fault
Err2: Non-Fe probe fault
Err3: Both probes.
Err4: Fe probe fault
Err5: Non-Fe probe fault
Coating thickness tester / English
7