Attaching The Fan Blades - HAMPTON BAY Pendleton El Manual Del Propietario

Attaching the
Fan Blades
1. Attach medallion to blade using two washer
head screws supplied (Figure 9). Start a
screw into the blade. Repeat for the remain-
ing screw.
2. Tighten each medallion securely.
3. Attach blade to blade bracket using the
screws as shown in Figure 10. Start a screw
into the bracket. Repeat for the two remain-
ing screws.
4. Repeat steps 1-3 for the remaining blades.
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
Figure 9
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on the
ceiling. Measure this distance as shown in
Figure 11. Rotate the fan until the next blade
is positioned for measurement. Repeat for
each blade. Measurement deviations should
within 1/8". Run the fan for 10 minutes.
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
Screws
Blade Bracket
Blade
Figure 10
TO REDUCE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING FAN BLADES.
Figure 11
7.