D End Panel Position - ubabub Pod U0400 Instrucciones

D
End panels position
Step 1 Insert Support Pins into the side panels as shown in the diagram.
Step 2 Select Lower Curved End. Select five Connecting Pins and install into Lower
Curved End as shown in the diagram using screw driver.
Step 3 Insert two Locking Cams on side panel.
Step 4 Using the edge of the plastic base as a guide, slide Curved End horizontally
until it joins tightly against side panel.
Step 5 Align the Locking Cams and connecting pins on Lower Curved End. Make
sure connecting pins are passing through the Locking Cams. Insert the
Locking Cam nuts. Use screwdriver to turn Locking Cam nuts clockwise until
tightened. (See Fig. D1).
Step 6 Starting with the center hole, using 55mm bolts attach end to base –
finger tighten only.
Step 7 Insert left and right bolts (using 55mm bolts), finger tighten only.
Step 8 Once all three bolts are in place, check alignment and tighten with Allen Key
Please note: Do not over-tighten.
Step 9 Repeat steps 1–8 on other side.
12