H Upper End Panel Position - ubabub Pod U0400 Instrucciones

H
Upper ends position
Step 1 Select Upper Curved End.
Step 2 Align inside recessed edges with acrylic, lower vertically onto Connecting Pins.
Step 3 Using four Pan Head Bolts attach acrylic side to Upper Curved End.
Step 4 Tighten all using screw driver. Please Note: Do not over-tighten.
Step 5 Insert Locking Cams on Upper Curved Ends.
Step 6 Align the Locking Cams and connecting pins. Insert the connecting pins to the
upper curved end. Make sure connecting pins are passing through the Locking
Cams. Insert the Locking Cam nuts. Use screwdriver to turn Locking Cam nuts
clockwise until tight. (See Fig. H1).
Step 7 Repeat Steps 5 & 6 until it is secured.
Step 8 Repeat Steps 1 to 7 with other Upper Curved End.
Fig. H1
6.1
Insert the
connecting pins
to the rails.
6.3
Use screwdriver to turn Locking
Cam nuts clockwise until tight.
x 8 Pan
Head Bolts
6.2
Insert the
Locking Cam
nut.
x 6 Locking
Cam
17