Using The Product - Greencut GGT200L Manual De Instrucciones

FRONT HANDLE
1. Press the button (14) on both sides, and mount the front handle
on the control handle.
2. Turn the front handle to the required angle.
3. Release the button and make sure the handle engages in a locking
position.
INSTALLING THE BATTERY
NOTE: The battery should be charged about 60 minutes before the first start.
1. Press the lock button and remove the battery from the device.
2. Insert the battery into the charger.
3. Plug the charger into the power supply.
4. The charge status is shown by the control lights. If all the lights are on, the charge is complete, if one led
is flashing you must recharge the battery and if all the leds are flashing it means that the battery is too hot
or too cold.
5. Insert the battery into the machine and make sure that it clicks into place correctly.

USING THE PRODUCT

BEFORE USING
1. Hold the unit with your left hand on the front handle, and your right hand at hip level on the top handle,
comfortably balanced.
START / STOP
1. To switch on, press the safety lock button (2) and simultaneously press the ON/OFF switch (1).
2. To turn the unit off, release the ON/OFF switch (1).
ADJUSTING THE LENGTH OF THE UNIT
1. Loosen the shaft adjustment ring (5)
2. Pull the telescopic pole to the desired length.
3. Retighten the shaft adjustment ring (5).
47
EN