Ordering Information - KAS 143 Instrucciones De Instalación

How to install the KAS
Follow the next steps to install the keypad.
1. Insert a slotted screwdriver to the notch on the bottom of the keypad, press and remove the backplate.
2. Use the mounting holes (no. 1 in the above figures) and mount the backplate on a flat surface. Make sure to use the tamper's hole
(no. 2 in the above figures), so the tamper will switch when the backplate is removed from the surface.
3. Insert the supplied batteries; observe polarity!
4. Enroll the keypad by pressing the enrollment button (no. 5 in the above figures); see how in the FORCE's Installation guide (in the
Wireless Peripherals
menu).
5. Attach the keypad to the mounted backplate, top side first, and press until clicked.
6. Test the keypad in the
Quick guide
The KAS' three LEDs at the top indicate, by illuminating for three seconds when any keypad operation is performed. For example, when
Alarm in Memory
arming, the
armed or not, and if faults exist.; refer to the
LEDs
LED and color
Fault, yellow
Arm, red
Alarm in memory, yellow
System status, green
Number keys
Key Press and hold to...
3 Arm in Home 3
4 Arm in Home 4
4 + 6 Generate Medical alarm
7 + 9 Generate Fire alarm
* + # Generate Panic alarm
Arm/Disarm keys
Key Press and hold to...
Arm Away Arm all the available zones/partitions
Arm in Home 1 Arm only the
Arm in Home 2 Arm only the
Disarm Disarm all the available zones/partitions (user code required)
Note, that if the KAS sounds three beeps, the arming operation is denied, because the alarm system is not ready to be armed; check an
LCD keypad for details.
Low battery
When the battery is low, when pressing and holding the asterisk (*) or pound (#) keys, the Fault LED will blink three times. If any other
fault exist, it will then illuminate for three seconds.

Ordering information

 KAS143: P/N 8833002
Tests and Diagnostics
menu.
LED will illuminate, if the alarm is or was triggered. The system status LED indicate if the alarm system is
LEDs
table below.
Indication
 Illuminates for three sec.: faults exist
 Blinks three times: low battery (KAS)
The alarm system (or partitions) is armed
The alarm is or was triggered previously
Press and hold the asterisk (*) or pound (#) keys - the LED
illuminates for three seconds, only if no fault exists, the
alarm system is disarmed, and no alarm is in memory.
Home 1
zones (or, enter user code and press the key)
Home 2
zones (or, enter user code and press the key)
 KAS187: P/N 8833014
-2
-