Fitting And Removing A Drill Bit Or Screwdriver Bit; Operating Instructions; Charging The Battery - Famastil F-POWER Manual De Instrucciones

FITTING AND REMOVING A DRILL BIT OR
SCREWDRIVER BIT
This tool is fitted with a keyless chuck to
allow for an easy exchange of bits.
First remove the battery from the tool.
01
Lock the tool by setting the
02
to the centre position.
selector (9)
WARNING! Let the tool work at its own pace. Do not overload!

CHARGING THE BATTERY

The battery needs to be charged before first use and whenever it fails to produce
sufficient power on jobs that were easily done before. When charging the battery for
the first time, or after prolonged storage, it will only accept an 80% charge.
After several charge and discharge cycles, the battery will attain full capacity.
The battery may become warm while charging. This is normal and does not indicate
a problem.
WARNING! Do not charge the battery at ambient temperatures
below 4 °C or above 40 °C. Recommended charging
PIC 1
direction

OPERATING INSTRUCTIONS

temperature: approx. 24 °C.
OPEN
03
Open the chuck by turning the front
part with one hand while holding the
rear part with the other (PIC 2).
04
Insert the bit shank (13) into the chuck.
05
Firmly tighten the chuck by turning the
front part with one hand while holding
the rear part with the other.
PIC 2
CLOSE
27