Selecting The Operating Mode Or Torque; Switching On And Off; Built-In Led; Built-In Level - Famastil F-POWER Manual De Instrucciones

SELECTING THE OPERATING MODE
OR TORQUE
This tool is fitted with a collar to select
the operating mode and to set the
torque for tightening screws. Large
screws and hard workpiece materials
require a higher torque setting than
small screws and soft workpiece
materials. The collar has a wide range
of settings to suit your application:
01 For drilling in wood and plastics,
set the torque selector to the drilling
position by aligning the symbol with
the marking (FIG6).
For screwdriving, set the torque
02
selector to the desired setting. If you do
not yet know the appropriate setting,
proceed as follows:
• Set the torque selector to the lowest
torque setting. (PIC 7).
• Tighten the first screw. If the clutch
SWITCHING ON AND OFF (PIC 8)
To switch the tool on, press the variable
speed switch. The tool speed depends
on how far you press the switch.
To switch the tool off, release the
variable speed switch.
ratchets before the desired result is
achieved, increase the torque selector
setting and continue tightening the
screw. Repeat until you reach the
correct setting. Use this setting for the
remaining screws.

BUILT-IN LED

When the screwdriver is turned on
pulling the trigger switch , the built-in
front LED will automatically turn on.
The LED will turn off when the trigger is
released.
PIC 8

BUILT-IN LEVEL

The built-in level at the top of the
screwdriver is to improve the precision
on drilling or using a wood screw. This
allows the user to control of the angle
of the drill / screw so that the hole can
be made more straight, improving the
ability to withstand weight.
HIGHER TORQUE
PIC 6
LOWER TORQUE
PIC 7
29