Initial Setup - Tripp-Lite DMTP55NO Manual Del Propietário

4. Initial Setup

4.1 Mounting
After unpacking the unit and assembling the optional mobile stand (sold separately), mount the unit according to the mobile
stand instructions.
4.2 Wi-Fi Antenna Connection
After mounting the unit securely to a mobile stand or wall mount, connect the included Wi-Fi antennas to the rear of the unit.
4.3 Camera Connection
Clip the included HD webcam to the top of the display. You can reposition it as needed. Using the included USB cable,
connect the webcam to the camera input at the rear of the unit.
4.4 Remote Control Setup
Insert the included AAA batteries into the included remote control. Follow the polarity (+/-) indicated in the battery compartment.
4.5 Power Connection
Connect one end of the included AC input power cord to the unit's C14 inlet. Connect the plug to a grounded 120V AC
outlet on the optional battery system. If you are not using the battery system, connect the plug directly to a properly
grounded 120V 15A AC wall outlet. The master on/off switch next to the C14 inlet must be in the "on" position for the unit
to function. Set the master on/off switch to the "off" position if the unit will be idle for more than a few days.
4.6 Initial Display (Android) Startup
Press the power button on the front of the unit or the remote control. After a brief startup sequence, the unit will be ready to
use. Select "menu" and enter the wireless network settings for your location. If you are unsure how to do this, contact your IT
department for the correct network settings.
4.7 Touch Input
Only use the included touch pens or fingertips on the screen surface. If you need additional touch pens, inexpensive
replacements are available from Tripp Lite.
4.8 Shutdown
Press the power button on the remote to shut down the display. If you intend to turn off the master on/off switch, wait until
the display has shut down completely.
10