Troubleshooting; Specifications - Tripp-Lite DMTP55NO Manual Del Propietário

6. Troubleshooting

Before contacting Tripp Lite, try the common solutions listed below.
Problem
No display. Power LED off.
No display. Power LED on or
blinking.
Remote control doesn't
function.
Any other problem.

7. Specifications

LED Display
Diagonal Size
Aspect Ratio
Pixel Format
Pixel Pitch
Brightness
Contrast Ratio
BLU Type
Color Depth
Viewing Angle (CR>10)
Touch Panel
Touch Technology
Detect Area
Touch Point
Touch Tool
Response Speed
Accuracy
Operation System
Possible Solution
1. Make sure the AC input power cord is connected firmly at both ends.
2. Make sure the master on/off switch by the power inlet is set to the on position.
1. Make sure the selected input source is active and the cable is connected to the correct
port at both ends.
2. Try pressing a key on the remote to wake the display.
3. Try turning the product off and on again.
1. Make sure to aim the remote at the IR sensor near the power button on the front of the
display.
2. Make sure the batteries do not need to be replaced. The batteries should last 6 to 12
months under typical conditions.
3. Make sure the batteries are installed with correct polarity (+/-), as shown in the battery
compartment.
Contact Tripp Lite support.
54.64 in. (1387.8 mm)
16:9
3840 x 2160
0.315 mm x 0.315 mm
350cd/m2 (Typ.)
1300:1 (Typ.)
D-LED Type
10-bit (D), 1.07 Billion Colors
R/L 178 (Min.), U/D 178 (Min.)
IR (Ultra Slim Infrared)
1209.6 (H) x 6804 (V) mm
Max. 20 Points (Android)
Hand or Other Solid Object ( Pen Tip >→3.0 mm)
<8 ms ( 1 Touch)
±1 mm
22