Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. SECURING FEET TO SUPPORT LEGS
Parts Required:
1
x
Left Front Leg (#9)
Left Back Leg (#10)
1
x
Left Front Leg Trim Piece (#13)
1
x
1
x
Left Back Leg Trim Piece (#14)
6
x
Screw (#D)
Installation:
•
Use three screws to attach the Left Front Leg Trim Piece to the Left Front Leg.
Continue to install the Left Back Leg and Left Back Leg Trim Piece.
2. SECURING SUPPORT PLATES
Parts Required:
1
x
Left Front Leg (#9)
1
x
Left Back Leg (#10)
1
x
Left Bottom Support Plate (#17)
Short Support Plate (#18)
1
x
Screw (#D)
8
x
Installation:
•
Install one Short Support Plate to the side of the unit between of a Front
and Back Support Legs using four screws. Repeat the same installation
to mount the Bottom Support Plate to the same legs.
NOTE: Make sure Bottom Support Plate is facing up with correct direction.
ASSEMBLY PREPARATION
ASSEMBLY INSTRUCTIONS
Customer Service for parts: Monday
®
1
10
9
13
2
10
9
18
17
14
5